我们介绍几点维护方案： 叉车电池在使用中，如果存在以下情况造成叉车电池亏电时，必须对叉车电池进行普通充电，在使用中，若单格电压降到1.75伏，即6伏电压降到5.25 伏，12伏电池降到10.5伏时，电解液密度降至1.170，应停止使用，进行普通充叉车电池在普通充电过程中，电解液的温度为多少比较合适？不能超过 45度，当接近45度时，应停止充电或减半充电电流，等待温度降到35度以下时可恢复或继续充电，如何看出叉车电池已经充满，可以结束充电？在充电过程 中，内部产生剧烈气泡，单格电压约2.4-2.8伏之间，电解液密度升到 1.280+-0.005(25度)，密度和电压2~3小时不变，即表示充电完全，可以结束充电，在充电时，如果电压已经调整到2.4~2.8伏之间，但 却出现密度达不到1.280+-0.005(25度)，应该采取什么措施？当密度过低时，用密度为1.4左右的电解液调整，密度过高时，用纯水调解，直到 的电液比重1.26~1.28到达为止，以上是叉车蓄电池大全及叉车电池品牌配套方案、使用维护方法。
we introduce Several maintenance plans: During the use of the forklift battery, if the following conditions cause the forklift battery to lose power, the forklift battery must be charged normally. During use, if the single cell voltage drops to 1.75V, that is, the 6V voltage drops to 5.25 When the 12-volt battery drops to 10.5 volts, the electrolyte density drops to 1.170. Stop using it. What is the appropriate temperature of the electrolyte during the ordinary charging of the forklift battery? It cannot exceed 45 degrees. When it is close to 45 degrees, the charging should be stopped or the charging current should be halved. When the temperature drops below 35 degrees, the charging can be resumed or continued. How can I tell that the forklift battery is fully charged and can end the charging? During the charging process, violent bubbles are generated inside, the single cell voltage is between 2.4-2.8 volts, the electrolyte density rises to 1.280+-0.005 (25 degrees), and the density and voltage remain unchanged for 2 to 3 hours, which means that the charging is complete. Charging can be ended. During charging, if the voltage has been adjusted to between 2.4 and 2.8 volts, but the density does not reach 1.280+-0.005 (25 degrees), what measures should be taken? When the density is too low, use the electrolyte with a density of about 1.4 to adjust. When the density is too high, use pure water to adjust until the precise electro-hydraulic specific gravity reaches 1.26~1.28. The above is the complete set of forklift batteries and forklift battery brand supporting programs. Use maintenance methods.
