科朗(CROWN)叉车蓄电池在新电池使用前，应该完全地充满电，需要循环充放电多次以达至容量，在这段期间，叉车蓄电池容量暂时未达到状态，叉车蓄电池接线应该是完整无缺，并且要与蓄电池接线头紧紧联系。林德叉车蓄电池应用的时候或充电期间，透气锁盖（蓄电池盖）应该是正确地安装和锁紧。叉车蓄电池应时常存放在干净，没有尘埃及腐蚀的地方。科朗叉车蓄电池组如需要加注电解液，应该充电之后进行。如电解液水平充电之前已低于隔板，必须加进电解液大约1/8”高过隔板方可充电。蓄电池在充电之后要检查电解液水平，保持在电池盖底部分约1/4”。科朗叉车蓄电池用来补充的液体，应该是纯蒸馏水。特别注意要避免有金属杂质混于蒸馏水内。为达至蓄电池寿命，当电池容量消耗80%以后建议不再使用。采用适当容量的电池能有助避免其过度放电。用正确充电器与电池之充电时间正常大约为8个小时。规格不符的充电器会严重地损坏或降低蓄电池的寿命。

Before the new battery is used, the battery of crown forklift truck should be fully charged, and it needs to be charged and discharged repeatedly to reach the maximum capacity. During this period, the capacity of the battery of the forklift truck has not reached the optimal state for the time being. The wiring of the battery of the forklift truck should be complete and closely connected with the battery connector. The ventilation lock cover (battery cover) should be properly installed and locked during battery application or charging of Linde forklift truck. Forklift batteries should always be stored in a clean, dust-free and corrosive place. If the battery pack of Kelan forklift truck needs to be filled with electrolyte, it should be charged before charging. If the electrolyte level is lower than the baffle plate before charging, the electrolyte must be added about 1 / 8 "higher than the separator before charging. After charging the battery, check the electrolyte level and keep it about 1 / 4 "at the bottom of the battery cover. The liquid used by the battery of Coran forklift truck should be pure distilled water. Special attention should be paid to avoid metal impurities mixed with distilled water. In order to reach the best service life of the battery, it is recommended that the battery should not be used after 80% of its capacity is consumed. Proper capacity of the battery can help to avoid excessive discharge. The normal charging time with the correct charger and battery is about 8 hours. The battery life will be seriously damaged or reduced if the charger does not meet the specifications.